Tighten the water pump bolts evenly so that the seal or liquid sealant is evenly distributed.

Therefore, observe the printed instructions on the sealant. Liquid sealants are also manufactured with different drying speeds. Too much sealant will jeopardise correct installation and may decompose in the cooling system and contaminate it. If you have applied too much sealant to the part, wipe off the excess before installing the new water pump. Apply an even bead of liquid sealant along the edge of the component, but do not use too much. Our mechanics therefore recommend lubricating a small amount onto the water pump and the seal. An important point when fitting the water pump is to use a liquid seal.

Too much time is lost with the old-fashioned tapping of a seal. This was chosen in order to be able to complete the repair as quickly as possible when we receive our water pump. Seals are supplied as standard with the water pumps. Old seals and gaskets must be replaced with new ones. Do not try to move the pump by hitting the pump shaft! Does the thermostat still work, does the radiator cap still work and are there no cracks or leaks in other parts? Step 6. Step 5.Ĭheck all radiator hoses and also the cooling system. All (seal) residues should also be removed until they become bare metal. The old gasket comes with the pump and must be removed from the engine. Loosen the screws of the water pump and remove it from the engine. Tractors are often old and maintenance has not always been optimal in the past. most of the cooling water will have drained off, catch it well due to environmental regulations! Our tip is to always flush the cooling water system thoroughly to remove all grease residues, waste and sand from the system. When removing the water pump, a number of hoses must be disconnected. Often this only requires loosening the radiator hoses and tilting the radiator forward to make room (for example on an Iseki TX1510).

Remove the fan belt if you can, and otherwise remove the radiator to create more space. The video and data of the Iseki water pump TK, TM, TU, TXG, SFH, SG, SGR, SXG, Sial, GEAS, TH.Īssembly of the water pump in 10 steps Step 1.Īlways wait until the engine has cooled down before carrying out maintenance work on the cooling system components. The video of the water pump K3A, K3B, K3C, K3D, S4L with technical data: Our well-known models are highlighted Iseki Water pump Iseki SIAL and the K3A-K3D/S4L water pump. To start with we started with Iseki water pumps. In addition, we have added all sizes of radiators. Now it is the turn of the water pumps, which according to our customer service need more details. Every two weeks we try to write a post about products, tractors or a fun fact.

Iseki hydraulic manual pumps